DeWalt D28885 Manual De Instrucciones página 22

• Securely tighten the collet using the 19 mm
spanner provided.
• Release the spindle lock.
• To remove the accessory, proceed in reverse
order.
Always mount the accessory with the
required length X of the shank inserted in
the collet (fig. D).
Never tighten the collet nut without an
accessory in the collet.
D28886 - Setting the electronic speed control
dial (fig. A)
The speed is infinitely variable from 7,000 - 27,000
-1
min using the electronic speed control dial (5).
• Turn the electronic speed control dial to the
required level. The correct setting, however, is a
matter of experience.
• Generally, harder materials require a higher setting.
Instructions for use
Always observe the safety instructions
and applicable regulations.
Ensure all materials to be ground or cut are secured
in place.
Apply only a gentle pressure to the tool.
Avoid overloading. Should the tool become hot, let it
run a few minutes under no load condition.
Prior to operation:
• Install the appropriate accessory. Do not use
excessively worn accessories.
Switching on and off (fig. A)
• To run the tool, press the on/off switch (1) to the
front.
• For continuous operation, press down the front
end of the switch.
• To stop the tool, release the on/off switch.
• To stop the tool in continuous operation,
press the rear end of the on/off switch.
Holding the tool
• Always hold the tool with both hands.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT repair
E
21