Stihl KMA 135 R Manual De Instrucciones página 32

English
► Switch off the KombiEngine and remove the
battery.
► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– The bump guard (3) fits between the loop
handle (1) and carrying ring.
– a = no more than 25 cm.
► Tighten down the screws (2) so that the loop
handle (1) cannot be rotated on the shaft.
10 Removing and Fitting the
Battery
10.1 Inserting the Battery
► Insert the battery (1) up to the limit stop into
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
10.2 Removing the Battery
► Set the KombiEngine on a level surface.
► Press both locking levers (1).
The battery (2) is released and can be
removed.
32
a
1
2
3
1
2
2
1
10 Removing and Fitting the Battery
11 Switching the KombiMotor
On/Off
11.1 Switching on the KombiEngine
► Hold the KombiEngine with your right hand by
the control handle – wrap your thumb around
the grip of the control handle (4).
► Hold the KombiEngine with your left hand on
the loop handle so that your thumb wraps
around the loop handle.
► Depress the trigger lockout (1) with your hand
and keep it pressed.
► Push the release slide (2) in the direction of
the loop handle with your thumb and hold it
there.
The LEDs emit light to indicate the power level
used last.
► Depress the trigger (3) with your index finger
and keep it depressed.
The KombiEngine accelerates and the Kombi‐
Tool runs.
The more you depress the trigger (3), the faster
the KombiTool runs.
The KombiEngine can also be switched on by
first pressing the release slide (2) and pressing
the trigger lockout (1) within 5 seconds (as long
as the LEDs are flashing). The trigger (3) is now
unlocked and the KombiEngine is ready for use.
The LEDs continue flashing for 5 seconds after
the trigger (3) and trigger lockout (1) are
released after the brushcutter is switched on. As
long as the LEDs flash, the KombiEngine can be
switched on again without having to operate the
release slide (2).
11.2 Switching the KombiEngine Off
► Release the trigger and trigger lockout.
► Wait until the KombiTool comes to a standstill.
► If the KombiTool continues to run: Remove the
battery and contact your STIHL dealer for
assistance.
The KombiEngine is defective.
2
1
4
3
0458-687-9802-A