UFESA Luxe Steam Glide Manual De Instrucciones página 19

Do NOT use abrasive cleaners, detergent or other chemicals to clean the Steam Station.
Change anti-scale cartridge
Replace the water softening cartridge regularly. At moderate use (twice a week) and de-
pending on the water hardness in your region the water softening anti-scale cartridge
should be replaced every 3-6 months.
Note: Do not use the unit without the water softening cartridge!
1- Remove the water tank from the station.
2- Pull anti-calc cartridge upwards and remove it for changing. In order to remove it, firstly
unscrew it and carefully take it out. Disconnect the hose from the cartridge and connect it
to the new cartridge. Screw the new cartridge back to the water tank.
Note: Be careful - there can be water inside the cartridge body.
Install a new water-softening cartridge to its place.
Troubleshooting Guide
Please consult troubleshooting table below for any issues you may face prior to contact-
ing our support centre.
PROBLEM
Unit fails to heat up and
steam. Power indicator
light does not
illuminate.
Water runs out of the
holes in the soleplate.
White streaks come
through the holes in the
soleplate.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
The soleplate is dirty or
brown and may stain
the garment .The clothe
sticks in the soleplate.
POSSIBLE CAUSE
Unit is not plugged in.
Water has condensed in the
pipes because you are using for
the first time or you have not
used it for some time.
The soleplate is not hot enough.
The product has a build-up of
scale because the anti-calc
cartridge has not been changed
regularly.
You are using chemical descaling
agents or addititves in the water
for ironing.
You are ironing at too high a
temperature.
SOLUTION
Plug into electrical outlet.
Press the steam trigger away
from your ironing board until the
iron produces steam.
Wait until the iron soleplate
is hot enough or increase the
temperature of the soleplate.
Change the anti-calc cartridge
Never add this type of product
in the water tank or in the steam
chamber.
Adjust the temperature dial to a
lower heat setting.
19