Zodiac Z250iQ Guia De Inicio Rapido página 8

5
Operation
Open the hydraulic circuit
• Close valve B gradually.
• Open valves A, C and D fully. Open valve E by half (the air built up in the condenser and the filtration circuit
will bleed out). If valves D and E are not present, open valve A wide and close valve C by half.
• Connect the power supply to the heat pump.
• If the heat pump is on standby, press
• Set the desired temperature.
Connecting to the Fluidra Pool app
Mobile
device
The heat pump can be remotely controlled from a smartphone or tablet, via the Fluidra Pool app available for
iOS and Android systems. Before connecting to the Fluidra Pool app, ensure that you:
• Use a Wi-Fi-enabled smartphone or tablet.
• Use a Wi-Fi network with a reasonably strong signal when connecting to the heat pump: the Wi-Fi signal
must be detectable at the place where the appliance is used. If this is not the case, a technical solution
must be provided to amplify the existing signal.
• Rest close to the appliance and have your home Wi-Fi network password at the ready .
Download the
Fluidra Pool app
(QR code on
the back of the
product)
8
for 3 seconds: Adjust the clock and select an operating mode.
Home Wi-Fi
network
"SET" flashes
+
Press and hold
CAUTION : An incorrect
by-pass setting may
cause the heat pump to
malfunction.
Heat pump
Open the application and follow the steps
described in the app to add the heat pump.
❶ Installation
❷ Use