Publicidad
Idiomas disponibles
Idiomas disponibles
Donotattempt to service a tire unless youhavetheproper
equipment andexperience t o perform thejob. Ifyouarenot
qualified t o maketherepairs, taketheunitto yourAriens
dealer o r a qualified repair service.
Whenseating tirebeads ontherims,neverexceed 2,4 bar
(35p.s.i.)orthe maximum inflation specified onyourtires.
Inflation beyond thismaximum pressure maybreak the
bead, o r eventherim,withdangerous e xplosive f orce.
Replacement
Parts
Where replacement parts are necessary for periodic
maintenance and servicing, genuine Ariens replacements
must be used.
Ariens does not claim responsibility for installation of
unapproved parts and/or accessories or damages as a
result of their use.
WARNING: AVOID INJURY! Read and
understand entire Safety Section before
proceeding.
UNPACK
UNIT
Remove all packing materials and hardware and literature
packages. Discard J hook used with strapping as it is not
needed for mower operation.
SETUP INSTRUCTIONS
Ariens mowers are shipped partially assembled. After
uncrating the power unit and mower deck, initial setup is
required.
IMPORTANT: During the unpacking of the crate all goods
should be matched against the packing list and all shortages
or damages should be noted and reported to the carrier
immediately.
Steering
Controls
1. The steering control levers may have been loosened
and moved forward for shipping. Remove the loose
3/8-16 x 1.75" bolts from the handles and reinstall
them in the location shown. Adjust the handles to fit
your comfort area.
Install
Bolt
Here
Figure 3
Seat Setup
1. Remove the loose 3/8" clevis pin, flat washers and rue
ring from the manual pack.
2. Carefully rotate the seat back far enough to install the
seat lock lever in the location shown in figure 3.
3. Connect the seat lock lever, figure 4, to the seat plate
using the 3/8" clevis pin, two 3/8" flat steel washers
and the rue ring.
Seat Lock Lever
Figure 4
Battery
The battery supplied with the mower is sealed, it will not be
necessary to activate it.
1. Connect the red positive cable to the positive (+) side
of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut. Cover
terminal with rubber boot.
2. Connect the black negative cable to Negative ( - ) side
of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut.
If the engine does not turn over by turning the ignition
switch, it may be necessary to charge the battery. (See
Charging the Battery on page 22.)
Deck
1. Remove knob from discharge shield.
2. Remove discharge assembly from Transport position.
3. Install discharge assembly in Operating position.
4. Reinstall knob in discharge assembly and tighten.
GB - 9
Publicidad
