Publicidad
Idiomas disponibles
Idiomas disponibles
EN
18
DEVICE OVERVIEW
1
Metal cover
2
Fuel filler cap
3
Control panel
Important information about this device:
•
Do not tilt the device more than 45 degrees or turn the device upside down
during transport. This can damage the compressor and the sealing system.
•
Remove all packaging materials, carefully inspect the device and make sure
that the device, power cord and plug are in good condition.
•
The device should be placed on a level surface. To ensure adequate
ventilation, the distance between the back of the ice cube maker and the wall
should be at least 150 mm and it should be kept away from stoves, radiators
or other heat sources.
•
Make sure that the mains voltage matches the voltage marked on the device.
•
Check regularly whether the filter screen of the water tank is clogged. After
the unit has been working for 100 hours, it is recommended to clean the water
tank filter screen with a fine brush to avoid clogging, which could lead to
abnormal operation of the whole unit.
4
Base plate
5
Ice collection tray
6
Handle of ice collection tray
Publicidad
