Publicidad
Idiomas disponibles
Idiomas disponibles
EN
22
Error detection and troubleshooting
•
ADD WATER: Under normal conditions, the ADD WATER indicator light is not
lit. If the ADD WATER indicator light is red and constantly on, it means that
the water tank does not have enough water. The device stops making ice. Fill
the water tank with water (the float switch will float on top). The ADD WATER
indicator light then goes out automatically and the device returns to normal
operating status.
•
ICE FULL: When the ice in the ice collection tray has reached maximum
capacity, the ICE FULL indicator light will turn solid white and the machine will
stop making ice. The ICE FULL indicator light then goes out automatically and
the device returns to normal operating status.
•
FREEZE ALERT: During the ice making process, if the low water, full ice,
cleaning and ice making indicator lights are flashing at the same time and
the CLEANING, LIGHT and ICE MAKING buttons are on at the same time, this
is a freeze alarm. In this situation, the power supply must be interrupted
immediately. Wait 4 hours for the ice in the evaporator to melt before turning
it on again.
OPERATION
1.
Open the lid and fill the water tank with water. There is a maximum MAX scale
in the water tank. The water should not exceed the MAX position. If the water
exceeds the maximum value, the excess water will flow into the lower water
tank.
2.
Connect the device to the mains. Press the ICE MAKING button once and the
device will start making ice. When the ice in the ice collection tray has reached
maximum capacity, the ICE FULL indicator light will turn solid white and the
machine will stop making ice. The ICE FULL indicator light then goes out
automatically and the device returns to normal operating status.
CLEANING AND CARE
•
Clean the inner liner, ice tray, water tank and ice scoop regularly. When
cleaning, unplug the power cord and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and outside of the ice
machine. Rinse thoroughly before use.
•
Keep the ventilation openings in the housing of the device free and make sure
that no water penetrates during cleaning.
•
Do not use mechanical devices or other means to speed up the defrosting
process.
Publicidad
