CAUTION
.This tube is designed for use by a person 6 years of age or
older.
.Never tie a person to the product or the cover. Never wedge
hands or feet under the cover or between the cover and the
product.
.Avoid sharp turns that can subject the product to rapid
acceleration.
.Do not attempt to ride the tube standing up.
.Know your own limits. Stop when you are tired. Act
responsibility.
.Do not attempt jumps or perform other risky maneuver with
the product. Attempting stunts, aerial tricks or jumps increases
the risk of being seriously injured. Use common sense at all
times.
.Because they are hard to steer, the best place to use the
tube is in a tubing park--often found at ski resorts.
.Check information on the applicable national legislation and
rules and regulations, familiarize yourself with the equipment
and its correct usage, and learn about the risks involved with
snow tubing.
VORSICHT
Read the
instructions.
Warning: Made
to withstand up
to 0.14
bar/2psi.
SIZE
Ø 46"/117CM
MAX NUMBER
PERSONS
06
Do not exceed
the maximum
load of
220lbs/100 kg.
Max number of
persons 1.
HOLEDIAMETER
Ø 15"/38CM
1
MAX LOAD
220LBS/100 KG
ASSEMBLY
.Place the tube into the cover before inflation.
.Fill the chambers until most of the wrinkles are gone and the
product feels firm to the touch but NOT hard. Do not over-inflate the
product.
NOTE: In strong sunlight or warm weather take into consideration
the expansion of the air. Only fill to 85% of the nominal pressure,
leave the product in the sun for a few minutes, and then check the
rigidity of the product.
NOTE: Never stand on or leave objects on the product during
inflation. Always check air leakage before using.
NOTE: Pumps for higher pressure (compressors etc.) can be used
with due caution - there is a considerable risk of over inflating and
damaging the product when using high pressure pumps.
INFLATION
ROPE ATTACHMENT
Use a tow rope specifically designed to pull inflatable tube
the rope must be properly attached to work correctly. Loop
end of the rope must go through hole (in the middle of the cleat)
prior to wrapping loop around cleat. Inspect molded tow cleat prior
to each use, if it shows signs of damage, cracking or breaking do
not use.
NOTE: Do not tow behind any vehicle.
NOTE: The line MUST be fastened correctly to work as intended.
DEFLATION
07