Publicidad
Idiomas disponibles
Idiomas disponibles
Before you call for service...
_._
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit GEAppliances.com.
You may not need to call for service.
PROBLEM
Possible Causes
What To Do
Dryer shakes or
Some shaking/noise is normal.
. Move dryer to an even floor space, or adjust leveling legs
makes noise
Dryer may be sitting unevenly
as necessary until even.
Clothes take too long
to dry
Improper or obstructed ducting
Check the Installation Instructions to make sure the
dryer venting is correct.
Make sure ducting is clean, free of kinks and
unobstructed.
Check to see if outside wall damper operates easily.
Improper sorting
_ Separate heavy items from lightweight items (generally,
a well-sorted washer loud is a well-sorted dryer load).
Large loads of heavy fabrics
. Large, heavy fabrics contain more moisture and take
(like beach towels}
longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
Controls improperly set
• Hatch control settings to the load you are drying.
Lint filter is full
_ Clean lint filter before every load.
Blown fuses or tripped circuit
. Replacefuses or reset circuit breakers. Since most
breaker
dryers use 2 fuses/breakers, make sure both are
operating.
Overloading/combining loads
_ Do not put more than one washer loud in the dryer at
a time.
Underloading
_ If you are drying only one or two items, add a few items
to ensure proper tumbling.
The Dry dryness level
Load consistsof a mixture
_ When combining heavy and light fabrics in a load,
was chosen but load is
of heavy and light fabrics
choose More Dry.
still damp
Exhaust system is blocked
. Inspect and clean exhaust system.
Control buttons not
Controls accidentally put in
, PressStart/Pause.
responding
service mode
Controls accidentally put in
. Hold the Lock Control button for 3 seconds to unlock the dryer.
lock mode
Controls performed an
* Resetthe in-house breaker.
incorrect operation
Dryer doesnt start
Control panel is "asleep"
• This is normal. PressPower to activate the control panel.
Dryer is unplugged
. Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown _circuit breaker
. Check the building's fuse/circuit breaker box and
is tripped
replace fuse or reset breaker. NOTE:Electricdryers
usetwo fuses or breakers.
Dryer was accidentally paused
. If the light on the Start/Pause button is flashing,
when starting Delay Dry
the dryer is paused. PressStart/Pause to restart
the countdown.
No numbers displayed
during cycle, only lights
Dryer is continuously
monitoring
the amount of
moisture
in the clothes
This is normal. When the dryer sensesa low levelof
moisture in the load, the dryer will display the dry time
remaining.
39
Publicidad
