MSW Motor Technics MSW-FBBD-150100D Manual De Instrucciones página 29

CHANGING THE SANDING BELTS
CAUTION: CHECK THE INSIDE OF THE BELT FOR A "DIRECTION ARROW". IF PRESENT, INSTALL THE
BELT WITH THE ARROW POINTING IN THE SAME DIRECTION AS THE DIRECTION INDICATOR ON THE
HOUSING.
1. Loosen the socket head screw using the 6 mm hex wrench provided.
2. Raise the belt sanding arm as shown.
3. Slide out one end of the tension lever as shown to release belt tension.
4. Remove the tray located on the bottom of the belt sanding arm by loosening the two screws on
the back of the belt sanding arm.
5. Slide the sanding belt off of the drive and idler drums.
6. Slide new sanding belt over the drive and idler drums. Ensure the belt is centred on both drums
and is the right way round.
7. Return the tension lever into its original position to apply tension to the belt.
8. Replace the tray and tighten the two screws on the back of the belt sanding arm.
9. Lower the belt sanding arm and tighten the socket head screw using the 6mm hex wrench
provided.
10. Before using, check belt tracking as described in the next section and adjust as necessary.
EN