MSW Motor Technics MSW-FBBD-150100D Manual De Instrucciones página 33

SURFACE SANDING ON THE BELT
When sanding flat broad surfaces on the belt hold the workpiece firmly on the surface of the belt and
against the backstop, keeping fingers away from the sanding belt. Consider using a push or hold-down
stick.
• Use extra caution when sanding very thin pieces, and when sanding extra-long pieces,
remove the backstop.
NOTE: When using the sander without the backstop, ensure that you have a firm hold on the workpiece at
all times and take extra care.
• Apply only enough pressure to allow the sanding belt to remove material.
SANDING CURVED PIECES
When sanding inside-curves on the belt sander, always sand on the idler drum end of the belt.
1. Hold the workpiece firmly, keeping fingers away from the sanding belt. Keep the curve pressed
firmly against the idler drum, moving the work evenly back and forth across the drum.
EN