Publicidad
Idiomas disponibles
Idiomas disponibles
This unit is capable of powering the following Accessories. The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
•
In Line Filter
Tire Air Chuck
Quick Connector Sets (various
sizes)
Air Pressure Regulators
Oil Fog Lubricators
Air Hose: 1/4", 3/8" or 1/2" I.D. in
various lengths
Refer to the selection chart located on
the unit to select the tools this unit is
capable of powering.
_The
use of any
--
other accessory
not recommended
for use with
this tool could be hazardous.
Use
only accessories
rated equal to
or higher than the rating of the air
compressor.
This air compressor pump is capable
of running continuously. However, to
prolong the life of your air compressor,
it is recommended
that a 50%-75%
average duty cycle be maintained; that
is, the air compressor pump should
not run more than 30-45 minutes in
any given hour.
Contents
of Carton
1 - Air Compressor
1-
Handle
1 - Grip Handle
4 - Self Tapping Screw
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1 - Rubber Strip
Tools Required for Assembly
2 -9/16"
open end wrenches
1 - 3/8" socket
Unpacking
1.
Remove unit from carton and dis-
card all packaging. NOTE: Save
all parts bags.
Assemble
Handle
1.
To make installation easier, sub-
merge handle grip into warm
soapy water. Remove handle grip
from soapy water and slide onto
handle.
2.
Insert the handle inside the com-
pressor saddle and line up the
two bolt holes on each side.
Handle
Grip
Shoulder
Bolt
3.
Install the four screws, two on
each side.
4.
Tighten securely.
Assemble
Wheels
_lt
will be necessary
to brace or support
one side of the unit when installing
the wheels because the compressor
will have a tendency
to tip.
N022059
10-ENG
Publicidad
