HomeMatic IP HmIP-ESI-GAS Manual De Instalacion Y Uso página 19

Start-up
6 Start-up
Only put the cover (B) on once
you have completed the mount-
ing and installation work.
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
access point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further informa-
tion, please refer to the operating
manual of the access point.
So that the device to be integrated into
your system and to communicate with
other Homematic IP devices, it must
first be paired on the Homematic IP
access point.
For pairing, proceed as follows:
• Open the Homematic IP app on
your smart phone.
• Select the menu item "Add device".
• Remove the cover (B) to open the
battery compartment (F).
1
2
1
• Pull the insulating strip out of the
battery compartment (F).
• The pairing mode is active for 3
minutes.
You can start the pairing mode for
a further 3 minutes by pressing
the system button (A) briefly.
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four dig-
its of the device number (SGTIN) in
your app, or scan the QR code. The
device number can be found on
the sticker supplied or attached to
the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
(A) lights up green. The device is
now ready for use.
1
2
1
19