Descargar Imprimir esta página

HomeMatic IP HmIP-ESI-GAS Manual De Instalacion Y Uso página 27

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Restoring factory settings
9 Restoring factory settings
The device's factory settings can
be restored. If you do this, you
will lose all your settings.
To restore the factory settings of the
device, please proceed as follows:
• When mounted, the cover (B) can
be easily removed from the mount-
ed device by pressing in the upper
and lower sides and pulling the
cover forward
• Remove a battery
(see
illustration).
• Insert the fresh battery making sure
that it is the right way around while
pressing the system button (A) at
the same time. Hold the system
button (A) down until the LED (A)
starts to flash orange rapidly.
Release the system button (A)
briefly and then hold the system
button (A) down again until the
orange flashes are replaced by a
green light.
(see
illustration).
4 s
Release the system button (A) again
to complete restoring the factory
settings.
The device will perform a restart.
10 Maintenance and cleaning
The device does not require you
to carry out any maintenance
other than replacing the battery
when necessary. Enlist the help of
an expert to carry out any repairs.
Clean the device using a soft, clean,
dry and lint-free cloth. Do not use any
detergents containing solvents, as they
could corrode the plastic housing and
label.
4 s
27

Publicidad

loading