Publicidad
Idiomas disponibles
Idiomas disponibles
TO USE CHOKE CONTROL (N)
Use choke control whenever you are start-
ing a cold engine. Do not use to start a
warm engine.
o To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD
AND
BACKWARD
The direction
and speed
of movement
is
controlled by the forward
and reverse drive
pedals.
1_ Start tractor and release
parking
brake_
2.
Slowly depress
forward (K) or reverse
(L) drive pedal to begin movement.
Ground speed increases
the further
down the pedal is depressed.
TO USE CRUISE
CONTROL
The cruise control
feature can be used for
forward
travel only.
SYSTEM
CHARACTERISTICS
The cruise control should
only be used
while mowing or transporting
on relatively
smooth,
straight surfaces_ Other conditions
such as trimming
at slow speeds
may
cause the cruise control to disengage.
Do
not use the cruise control on slopes,
rough
terrian
or while trimmimg
or turning.
- With forward
drive pedal depressed
to
desired
speed, pull cruise control
lever
(J) up and hold while lifting your foot off
the pedal, then release
the lever.
To disengage
the cruise control,
depress
the brake pedal or tap on forward
drive
pedal,
TO ADJUST
MOWER
CUTTING
HEIGHT
The position of the attachment
lift lever (A)
determines
the cutting
height.
• Put attachment
lift lever in desired
cut-
ting height sloL
o Slide pointer
tab (T) to desired
cutting
height as a reminder
for next time you
mow.
The cutting
height
range is approxi-
mately
I" to 4". The heights
are mea-
sured from the ground
to the blade tip with
the engine not running.
These heights
are approximate
and may vary depending
upon soil conditions,
height of grass and
types of grass being mowed.
• The average
fawn should
be cut to ap-
proximately
2-1/2
inches during
the coot
season and to over 3 inches during hot
months.
For healthier
and better looking
lawns, mow often and after moderate
growth.
o For best cutting
performance,
grass over
6 inches in height should
be mowed
twice.
Make the first cut relatively
high;
the second to desired
height.
TO ADJUST
GAUGE WHEELS
Gauge wheels
are properly
adjusted
when they are slightly
off the ground when
mower is at the desired
cutting
height in
operating
position.
Gauge
wheels then
keep the deck in proper position
to help
prevent scalping
in most terrain conditions.
NOTE: Adjust gauge wheels
with tractor
on a flat level surface.
1. Adjust mower to desired
cutting
height
(See "TO ADJUST
MOWER
CUTTING
HEIGHT"
in this section
of manual).
2. With mower in desired
height of cut
position,
gauge wheels
should
be
assembled
so they are slightly
off the
ground.
Install gauge wheel in appro-
priate hole. Tighten
securely.
3.
Repeat for all, installing
gauge wheel
in
same adjustment
hole_
15
Publicidad
