Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Depress
forward drive pedal to full
forward position
and hold for five (5)
seconds
and release
pedal, Depress
reverse drive pedal to full reverse posi-
tion and hold for five (5) seconds
and
release
pedal° Repeat this procedure
three (3) times.
5.
Shutoff engine
and set parking
brake.
6.
Engage
transmission
by placing
free-
wheel control
in engaged
position
(See
"TO TRANSPORT"
in this section
of
manual)°
7.
Sitting in the tractor
seat, start engine°
After the engine is running,
move
throttle
control to half (1/2) speed.
Disengage
parking
brake.
8.
Drive tractor forward for approximately
five feet then backwards
for five feet.
Repeat this driving
procedure
three
times.
Your transmission
is now purged
and now
ready for normal
operation.
MOWING TIPS
= Tire chains cannot be used when the
mower housing is attached to tractor,
o Mower should
be properly leveled for
best mowing performance.
See "TO
LEVEL MOWER
HOUSING"
in the
Service and Adjustments
section of this
manual.
o The left hand side of mower should
be
used for trimming.
o Drive so that clippings
are discharged
onto the area that has already
been
cut° Have the cut area to the right of
the tractor.
This will result in a more
even distribution
of clippings
and more
uniform
cutting.
o When mowing
large areas, start by
turning
to the right so that clippings
will
discharge
away from shrubs,
fences,
driveways,
etc. After one or two rounds,
mow in the opposite
direction
making
left hand turns until finished.
f
I
J
o If grass is extremely
tall, it should
be
mowed twice to reduce
load and pos_
sible fire hazard from dried clippings.
Make first cut relatively
high; the second
to the desired
height.
o Do not mow grass when it is wet. Wet
grass will plug mower and leave undesir-
able clumps.
Allow grass to dry before
mowing.
° Always
operate
engine
at full throttle
when mowing
to assure
better mow_
ing performance
and proper discharge
of material.
Regulate
ground speed by
selecting
a low enough
speed
to give the
mower cutting
performance
as well as
the quality of cut desired,
° When operating
attachments,
select a
ground speed that will suit the terrain
and give best performance
of the at-
tachment
being used.
19
Publicidad
