Descargar Imprimir esta página

Craftsman 917.27686 Manual Del Operador página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART:
See appropriatesectionin
manualunless
directedto
Sears servicecenter
PROBLEM
CAUSE
.................................. CORRECTION
Will not start
1. Out of fuel.
2o Engine
not"CHOKED"
properly.
3.
Engine flooded.
4o Bad spark plug.
5. Weak or dead battery.
16. Dirty air filter.
17. Dirty fuel filter.
i8.
Water in fuel
i9.
Loose or damaged
wiring.
10. Carburetor
out of adjustment.
11. Engine valves out of
adjustment.
1o Fill fuel tank.
2. See 'qO START ENGINE"
in
Operation
section.
3, Wait several minutes
before
attempting
to start.
4.
Replace
spark plug.
5.
Recharge
or replace
battery.
6. Clean/replace
air filter.
7.
Replace
fue! filter.
8.
Empty fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace
fuel filter.
9. Check
all wiring.
I0o See "To Adjust Carburetor"
in Service
and Adjustments
section.
t 1.Contact
a Sears or other
qualified
service
center.
Hard to start
Engine will not
turn over
1. Dirty air filter.
2.
Bad spark plug.
3. Weak or dead battery.
4.
Dirty fuel filter°
5.
Stale or dirty fuel.
6.
Loose or damaged
wiring.
7_ Carburetor
out of adjustment.
8_ Engine valves
out of
adjustment.
1. Brake pedal not depressed.
12. Attachment
clutch is engaged.
j3.
Weak or dead battery.
4.
Blown fuse.
5.
Corroded
battery
terminals.
6.
Loose or damaged
wiring.
7.
Faulty ignition switch.
8_ Faulty solenoid
or starter_
9. Faulty operator presence
switch(es).
1. Clean/replace
air filter.
2.
Replace
spark plug.
3.
Recharge
or replace
battery.
4.
Replace
fuel filter.
5.
Empty fuel tank and refill tank
with fresh, clean gasoline.
6. Check
all wiring.
7o See "To Adjust Carburetor"
in
Service
and Adjustments
section.
8. Contact
a Sears or other
qualified
service
center.
,,, ,,, ,,,,,, ,,,,,,, ,,,,,
, ,,,,,
,,
,,
!.
Depress
brake pedal.
2.
Disengage
attachment
clutch.
3.
Recharge
or replace
battery.
4.
Replace
fuse.
5. Clean
battery
terminals.
6. Check
all wiring.
7. Check/replace
ignition switch.
8. Check/replace
solenoid
or
starter.
9. Contact
a Sears or other
qualified
service
center.
Engine clicks but
will not start
Loss of power
1. Weak or dead battery.
2.
Corroded
battery
terminals.
3.
Loose or damaged
wiring°
4.
Faulty solenoid
or starter.
1.
Cutting
too much grass/too
fast.
21 Throttle
in "CHOKE"
position.
Build-up
of grass, leaves and
trash under mower.
4.
Dirty air filter°
5.
Low oil level/dirty
oil.
1. Recharge
or replace
battery.
2. Clean
battery
terminals.
3. Check
all wiring°
4. Check/replace
solenoid
or
starter.
1.
Raise cutting
height!reduce
speed.
2. Adjust throttle
control.
3o Clean
underside
of mower
housing.
4. Clean/replace
air filter.
5. Check
oil level/change
oil.
32

Publicidad

loading