Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.OPERATION
4.1 Drying
To switch the hand dryer on it must be plugged, the internal illuminated switch
must be ON.
NOTICE: When the device is delivered the internal switch is ON, so it is not
necessary to remove the front cover to activate it.
When hand dryer is switched on, it automatically carries out an internal check;
after some seconds it will be ready to use. The right way to use the hand dryer is
by introducing vertically both hands, separated, so that they can be correctly
detected by IR sensors.
When motor starts, countdown will be shown on the display of the device, which
is similar to a barcode. The optimal drying time would be one cycle of the
barcode display. However if the user wishes to continue with the drying, another
cycle will start automatically without being necessary to remove hands and
introduce them again. Maximum drying time is 30 seconds.
If logo blinks, it means that there is an issue with IR
sensors or that the 30 seconds drying cycle is over
Hand dryer automatically switches off when removing hands.
Dura�on of drying cycle
1 2 3 4
Pag.10
Alarms
Publicidad
