Jofel JET SMART Manual De Instrucciones página 29

EN
5. MAINTENANCE
• Water tank full( ). When the logo is ON it means that the wáter tank is almost
full and must be empty and cleaned. In order to do it, please follow instructions
from point 6 CLEANING OF WATER TANK.
• HEPA Filter (1). It activates when suction is blocked or when HEPA filter is
saturated. Hand dryer will stop functioning; filter must be replaced.
To do so, remove filter cover, situated at the bottom of the device. It is fixed by
means of one screws, which can be unscrewed by rotating 90 . Cover will come
off and then filter can be removed easily.
Fixing screws
HEPA filter cover
o
rotate 90
• Motor brushes (3). Notification of wear of motor brushes, they need to be
replaced. After replacement of brushes, please reset the motor counter
following instructions included further in this section.
• Jofel logo (blinking). It means that 30 seconds programmed drying cycle is
finished. If sensors detect a static object for longer than 30 seconds, the device
will automatically stop.
HEPA Filter
Pag.12
Water tank