Clutch Control - Husqvarna TE 250 2009 Manual De Uso

MUM1-250_310_450_510_2009_GB
R.H. HANDLEBAR COMMUTATOR (TE-TXC-
SMR)
The right commutator has the following controls:
1) Engine start button
3) Engine start - stop switch (TE-SMR)
TE-SMR
TXC
21-05-2008 9:28 Pagina 19
L.H. HANDLEBAR COMMUTATOR (TE-SMR)
CONTROLS:
1) High beam flash (self cancelling)
2) Selection control High beam
Selection control Low beam
3) Left turn signals (automatic return)
Right turn signals (automatic return)
To deactivate the turn signals, press the control lever after its re-
turning to center.
4) Warning horn
1
ENGINE STOP BUTTON (TC-TXC)
On the left side of the handlebar, near the clutch control, is locat-
ed the engine stop button.

CLUTCH CONTROL

The hydraulic clutch control lever is located on the left-hand side
of the handlebar and is protected against dirt with a rubber
guard.
The clutch control position on the handlebar can be adjusted by
loosening the lower fastening screw (A).
CAUTION
Do not forget to tighten the screw after the adjustment.
TC-TXC
1
19