Clutch Control - Husqvarna TE 310 I.E. 2010 Manual De Uso Y Mantenimiento

R.H. HANDLEBAR COMMUTATOR (TE-TXC-SMR)
The right commutator has the following controls:
1) Engine start button
3) Engine start - stop switch (TE-SMR)
TE-SMR
TXC
18
L.H. HANDLEBAR COMMUTATOR (TE-SMR)
CONTROLS:
1) High beam flash (self cancelling)
2) Selection control High beam
Selection control Low beam
3) Left turn signals (automatic return)
Right turn signals (automatic return)
To deactivate the turn signals, press the control lever after its
returning to center.
4) Warning horn
1
ENGINE STOP BUTTON (TC-TXC)
On the left side of the handlebar, near the clutch control, is lo-
cated the engine stop button.

CLUTCH CONTROL

The hydraulic clutch control lever is located on the left-hand
side of the handlebar and is protected against dirt with a rub-
ber guard.
The clutch control position on the handlebar can be adjusted
by loosening the lower fastening screw (A).
CAUTION
Do not forget to tighten the screw after the
adjustment.
1
TC-TXC