Hamilton Beach Commercial HBH550R Serie Manual De Operación página 7

Sanitizing
Sanitize using 1 Tablespoon (15 mL) of household bleach per 1 gallon (3.8 liters) of clean,
cool water (60°F/16°C), mixed according to the instructions on the bleach.
1.
Fill Jar with sanitizing solution, replace Lid and
Filler Cap or Dosing Cup and run on LOW speed
for 2 minutes. Empty Jar.
2.
Wipe exterior with soft cloth dampened with
sanitizing solution.
3.
Immerse Lid and Filler Cap or dosing Cup in
sanitizing solution for 2 minutes.
Maintenance
Inspect the Blender and its various parts and replace as follows:
Daily
Weekly
Quarterly
Troubleshooting
Problem
Blender fails to start,
or stops while it is
running and cannot
be restarted.
Ingredients will not
mix properly.
Unplug the Blender and remove Jar from Blender Base, then inspect Jar and
cutter assembly for wear, nicks, and broken or loose blades. Replace if necessary.
If blades are loose, discontinue use immediately and replace blades.
Do not attempt to repair or tighten cutter assembly. See "Technical Services."
Unplug the Blender, then inspect power cord insulation and power plug for cracks.
Refer to "Technical Services" for repair or replacement.
Replace Jar and cutter assembly as needed if inspection finds wear, nicks, or
broken or loose blades. See "Technical Services."
Solution
• Check to see if unit is securely plugged into an electrical socket.
• Check to see if integrated circuit breaker has tripped and reset it, if needed.
• Check to see if fuse for electrical socket has blown or if a circuit breaker has
tripped.
• If motor stops during operation due to overheating, unplug and allow the unit to
cool down for 15 minutes. Plug unit back in after 15 minutes to resume normal
operation.
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" cubes.
• Jar is too full. Do not fill past highest graduation marking.
• Cutter assembly blades are not sharp or are damaged. Inspect Jar and cutter
assembly daily. Replace Jar and cutter assembly as needed if inspection finds
wear, nicks, or broken or loose blades. See "Technical Services."
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
4.
Place empty Jar on Base and run on HIGH
speed for 2 seconds to remove any moisture
from the cutter assembly.
5.
When ready to use, rinse with clean water.
7