Publicidad
Idiomas disponibles
Idiomas disponibles
Drag Screw must be adjusted against the Feed Rod so that main
housing moves freely up and down the feed
rods when feed wheel is turned, so that main housing stays in
position on feed rod when wheel is released.
1.
Adjustment is made with magnet on and glide
posts over work surface.
2.
Remove front glide post lock screw, and loosen
rear glide post lock screw.
3.
Screw both glide posts up until the ends are
above the work surface.
4.
Place a .040" shim under the front glide post and
a 0.125" shim under the rear glide post.
5.
Screw glide posts down, compressing plungers,
until the body of the glide posts rest on the shims.
6.
Replace the front lock screw and tighten both the
front and rear lock screws.
1.
Adjustment is made with Magnet ON and impactor
over the work surface.
2.
Loosen Heads of Front and Rear Impactors
(Detail No. 25)
3.
Screw Impactor Points (Detail No. 26) up (counter-
clockwise) until point just touches work surface.
4.
Screw Impactors down (clockwise) until point just
touches work surface.
5.
Screw Impactor Points 1/2 turn further toward
work surface. (It may be necessary to turn off
Magnet while advancing Impactor).
6.
Tighten Heads.
FEED ADJUSTMENT
GLIDE POST ADJUSTMENT
Lock Screw
IMPACTOR ADJUSTMENT
6
Drag Screw
Glide Post
Impactor
Head
Impactor
Point
Publicidad
