EMAK BT 3000 Instrucciones De Uso página 41

d) Stopping the motor
Wait until the shredder is empty before stopping it as plant matter left in the feeding chute or blade casing
could jam the rotor when restarting the machine.
B&S 550 SERIES
Warning: because of rotor inertia, the stop time is relatively long.
e) Unblocking obstructions (wear gloves)
- Disconnect the spark plug cable.
- Remove branches from the feeding chute.
- Completely unscrew the lever of the obstruction clearance hatch.
- Slightly pivot the door so that you can pull it and then fully pivot downwards.
- Clear all the plant matter jamming the shredder
(check there is no plant matter in the feeding chute and discharge chute).
- Close the hatch (follow instructions in reverse). make sure the lever is fully screwed back down.
(Impossible to restart the shredder if the lever does not press on the contact switch).
1
1
1
3
2
2
2
4
12 - EN