Furius FLEX 121 Manual De Usuario página 28

• Do not leave the equipment connected to the electrical outlet or with the switch in the ON position with-
out attention.
• Only place the electrode holder clamp or torch on an insulated surface regardless of whether the elec-
trode connected or not. Avoid shorting with the work clamp (ground). Remove the electrode from the
electrode holder if the welding process is interrupted or has ended.
• Place the machine switch in the OFF position at the rear of the equipment and disconnect the power cord
from the electrical outlet each time changes are made in the work area, when removing the electrode
holder, torch, or clamp. work (ground) and when transporting or cleaning equipment.
• Pay special attention to the condition of the power cable, if the cable is damaged, repair it with a qualified
electrician, PREFERENTLY take it to an Authorized Service Center by FIXER BY UJUETA, S.A. DE C.V.
• Avoid tensioning the cables, do not move the machine by dragging it from the cables, if you need to
move it, disconnect it from the outlet. Do not use the power cord to suspend the machine, move it, or pull
it to disconnect it from the electrical outlet. Keep the power cord away from heat, oils, pointed surfaces, or
moving parts. A cable in poor condition increases the risk of electric shock.
• Pay attention to the condition of the electrode holder, torch and work clamp (ground) cables, especially
if they malfunction during the welding application or when the application result is not adequate. Check
the whole set: connectors, electrode holder, torch, work clamp, repair or replace them with a qualified
electrician, PREFERENTLY take it to an Authorized Service Center by FIXER BY UJUETA, S.A. DE C.V.
• Avoid contact with the electrical circuit, it can have negative consequences for the operator's health.
• The low DC voltage of the machine output makes it suitable for use in confined or humid spaces. Howev-
er, excessive moisture or sweating on clothing should be avoided. Make sure there is an insulated surface
where the machine can be placed.
• Pay attention to grounding systems when welding on electrically operated equipment or systems.
Improper connections to your welding equipment can allow welding process current to flow through the
grounding system. Always connect the work clamp as close as possible to the welding area, avoid placing
it in a random place.
• In the event of an accident, disconnect the machine from the electrical outlet immediately.
3
YEAR
WARRANTY