Ombréa 15-728851 Instrucciones De Montaje página 38

Place a GO louver in the correct direction as shown in the diagram, then fasten the KO main
louverend cap to the right of the louver and LO-1 to the left, using WO screws and the ZO-6 bit.
This louver will be your main louver. Repeat the operation to assemble your second main louver.
LO-1
ZO-6
WO
Repeat the same operation with the other GO louvers, fitting the LO-1 louvers end cap on the left
LO-1
ZO-6
WO
×2
GO
GO
and LO on the right.
×48
GO
GO
KO
GO
WO
LO
GO
WO
KO
ZO-6
LO
ZO-6
38