Publicidad
Idiomas disponibles
Idiomas disponibles
Fasten the FO connection bar to all the blades in the following order:
- Insert two VO pieces into the XO-2 bolt,
- Pass the assembly through the louver end cap, then add the plastic nut UO-1.
- Pass the assembly through the FO connection bar,
- Add a VO part and a UO nut.
To complete the operation, use a screwdriver, the ZO-6 bit and the ZO-5 spanner to hold the
nut in place.
Repeat the operation on all the blades, as shown in the diagram.
1
×50
3
plastic nut
×3
VO
UO
FO
XO-2
UO-1
plastic nut
VO
UO
XO-2
UO-1
FO
2
×2
VO
XO-2
FO
4
×2
VO
XO-2
FO
×1
VO
UO
FO
UO-1
plastic nut
FO
UO-1
plastic nut
×1
VO
UO
41
Publicidad
