Insert the cylinder PO through the beam as shown in the drawing, then push the part until the
connection with the pin from the main louver.
Combine and faster the first part of the box OO with the Gearbox NO onto the beam BO with the
bolts YO, using the Allen key ZO-3 or a screwdriver and the hex bit ZO-4.
KO
KO
PO
NO
PO
YO
OO
SO
Check if the louver rotates correctly from left to right and vice-versa using the hand crank HO.
Place the louver in a vertical position, in the right direction as shown to place and insert the
remaining louvers one after one.
Then, insert the half-moon plastic cap SO as shown in the drawing. The half-moon opening should
stay at the bottom of the cap.
40