Method Of Operation; Driving Depth Adjustment Dial; Air Supply - Interchange CRN4500 Manual Del Operador

CRN4500
Item No. 65690
8
OPERATINg ThE NAILER

METhOD Of OPERATION

Bump fire (Multi-fire)
ƒ Precaution must be taken when using this style
because unintentional firing can occur if trigger is
pulled and the safety is pushed down.
1. With your finger pulling the trigger, press the safety
all the way down on the surface of the material the
fastener is being driven into.
2. This will result in a fastener being driven into the
material.
3. To fire another round, raise the safety completely off
the material and repeat the above steps.
1

DRIVINg DEPTh ADjUSTMENT DIAL

1
Warning:
ƒ Always disconnect air supply before changing the
adjustment dial.
A
ƒ With air pressure set, drive nails into a piece of scrap
material to determine if an adjustment is necessary.
ƒ If adjustment is required, disconnect air supply.
ƒ Refer to the mark on the contact arm for direction to
turn the adjustment dial.
ƒ Reconnect air supply.
Interchange Brands Coil Nailers: Operator's Manual