Benning CC 1 Instrucciones De Servicio página 9

6. Environment conditions:
- T he BENNING CC 1 is intended for making measurements in dry
environment.
- M aximum barometric elevation for making measurements: 2000 m,
- O vervoltage category IEC 60664/ IEC 61010, 300 V category III,
600 V category II,
- Contamination degree 2 according to EN 61010-1
- Protection Class: IP 30 (DIN VDE 0470-1 IEC/ EN 60529)
I P 30 means: Protection against access to dangerous parts and protection
against solid impurities of a diameter > 2.5 mm, (3 - first index). No
protection against water, (0 - second index).
- O perating temperature and relative humidity:
F or operating temperatures from 0 °C to 30 °C: relative humidity less than 80 %
F or operating temperatures from 31 °C to 40 °C: relative humidity less than 75 %
F or operating temperature from 41 °C to 50 °C: relative humidity less than 45 %
- S torage temperature: The BENNING CC 1 can be stored at any temperature
in the range from 20 °C to + 60 °C ).
7. Electrical specifications
Note: The measuring precision is specified as the sum of
- a relative fraction of the measured value and
- a current value in A.
The measurement precision applies at a temperature of 23 °C ± 5 °C and a
relative humidity less than 75 %.
7.1 Alternating current measurement
Measurement
range
400 A
Max. equivalent source resistance: 75 Ω
8. Making measurements with the BENNING CC 1
8.1 Preparations for making measurements
Operate and store the BENNING CC 1 only at the specified storage and
operating temperatures. Avoid continuous insulation.
- T he nominal voltage and current ratings of the safety measuring
cables included in the scope of delivery correspond to the ratings of the
BENNING CC 1.
- T he safety measuring cable is securely connected to the BENNING CC 1
and cannot be removed.
- C heck the insulation of the safety measuring cables. Discard the
BENNING CC 1 immediately if the insulation is damaged.
- D o not clamp the measuring pliers on a live conductor before the
BENNING CC 1 has not been connected to a multimeter.
S trong sources of interference in the vicinity of the BENNING CC 1 can lead
to unstable readings and measuring errors.
- Do not apply any voltage to the output contacts of the BENNING CC 1.

Do not exceed the maximum permitted voltage with respect to
earth potential! Electrical danger!
The highest voltage, that may be applied to the BENNING CC 1 against ground
potential, is 600 V.
12/ 2005
Measured
value
3 A
30 A
350 A
400 A
BENNING CC 1
Output Measurement precision
3 mV
30 mV
350 mV
400 mV
± (1,9 % + 0,5 A)
at 50 Hz - 60 Hz
± (3,2 % + 1 A)
at 50 Hz - 60 Hz

7