Sinbo SS 4039 Manual De Instrucciones página 12

* Push the release button, and then open the shaving head(Fig.10)
* Clean the beard carbine by the brush(Fig.11)
Cutter cleaning
* Clean the cutter once every two months.
* Push the release button, and the open the shaving head.
* Rotate the fixing stand knob of cutter counterclockwise, and take the fixing stand of
cutter down(Fig.12)
* Take the cutter down from head cover in sequence(Fig.13)
* Use the cleaning brush to clean the blades(Fig.14)
* Use the cleaning brush to lean the foils(Fig.15)
* If necessary, use a fat removal liquid (like alcohol) to clean the foils;and lubricate the
foil with a drop of sewing machine oil, it can prevent foils from being worn up(Fig.16)
* Install the cutters back into the head cover, and then install the fixing stand of cutter
back to the shaving head.
Cutter replacement
* Replace the cutters every two years for ideal shaving performance.
* Use SINBO FR8 cutter to replace the old or damaged one for better shaving performance.
Environmental protection
The battery installed in the shaver contains material that shall pollute the environment,
if you decide to dispose the product, please dismantle the batteries and throw them to
the government designated places or recycling department.
1. Turn on the shaver until the battery power is used up.
2. Switch off the shaver and disconnect it with supply mains before dismantling the
battery from the shaver.
3. Loose the back cover by a screw driver, and dismantle the battery with electric iron
or pliers(Fig.17,18).
4. Do not connect the shaver with supply mains after dismantling the battery, and prevent
anode and cathode from circuit connection.
FEATURES
- Floating head, Pop-up trimmer
- 3 Stainless steel blades
- Ultra-thin precision shaving head
- Touch switch
- Running time: 60 minutes
- Accessories: 1x power cord, 1x clean brush
- AC230V, 50Hz, 2W
- 11 -