Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Insert the cable (1) into the control box connection (2).
NOTE: The light on the sensor will flash and the faucet
control box will make a "click" sound when you move
your hand in the sensor area. If not, check to ensure the
batteries are installed correctly.
7. Install the weight clip (F) at the point of the hose (1)
marking "weight here". Be sure to position the weight
clip (F) correctly in the hose, with the markings "UP"
facing upward. Insert the weight with integrated
batteries (H) onto the clip (F) by sliding it down onto
the clip (F).
NOTE: During the installation process, the weight with
integrated batteries (H) has the side marked with
"Weight with integrated batteries" must be facing
upwards.
8.
Making the water supply connections：
Thread the nut (1) on the supply line onto the
outlet of the water supply valve (2) and tighten
with a wrench. Do not overtighten.
NOTE: The hot side inlet tube is indicated by a label.
Avoid twisting wires together or placing the wires
close to each other and damaging.
6
7
F
8
1
2
8
H
H
G
F
1
2
1
Publicidad
