VEVOR AT-60 Manual Del Usuario página 10

L-Mode (Loop Mode)
You can preset the quantity of pieces which will be cut out.
(Maximum 999 pieces)The machine will cut out the pieces based on
your selected quantities then it will stop.
Press the SELECT BUTTON and decide the length of tape
Press and hold SELECT BUTTON so that DISPLAY will indicate
"Lcon"
Set the number of pieces to be cut out by using +/- BUTTON
When you press the START BUTTON,DISPLAY indicates a signal
that shows numbers backwards and cutting continuously.
When the DISPLAY indicates "0", the buzzer will make a sound
then the machine is stopped.
To stop the machine while running under L-MODE, press the
STARTBUTTON.
How to Manage a Curling Tape
Press the HOLD DOWN ROLLER RELEASE BUTTON in order to
open the HOLD DOWN ROLLER UNIT
Extend the ROLLER LOCK LEVER so that the roller will not turn.
Close the HOLD DOWN ROLLER UNIT
With the rollers locked, the tension may cause the length to vary.
Cut several test pieces in order to adjust the length if needed.
Use Narrow Tape /Use Two Rolls in a Same Time
If the tape is less than 15 mm in width or you want to dispense two
rolls at the same time, use the SEPARATOR.
Cut less than 10 mm width of tape, put the GUIDE PLATE on the
SEPARATOR
Remove the SEPARATOR from the bottom of body
Open the HOLD DOWN ROLLER UNIT
Insert the SEPARATOR into the body by slotting into the bottom of
the cavity
When you cut the tape less than 10 mm, put the GUIDE PLATE
onto the Separator.
Place one roll of the tape on either side by inserting a
SEPARATOR for loading tape
- 9 -