Press the START BUTTON once, the machine will feed-in a piece
of tape then cut it out based on your set length.
When that piece of tape is removed, the machine will feed-in
another piece then cut it out.
The machine will feed-in and cut a new piece of tape once the
piece of tape is removed.
P-Mode (Preset Mode)
The machine is able to be programmed.A signal will be shown
based on your selected quantity of pieces and it will all cut
out.(Maximum 999 pieces.)
A buzzer will have a sound when the program is finished.
You can use the mode either MANUAL or AUTO
Press SELECT BUTTON to choose your needed length.
Press SELECT BUTTON for three seconds then it will indicate
"Lcon"
Press SELECT BUTTON again then it will indicate "p".
Use +/- BUTTON and set the needed quantity.
Choose AUTO or MANUAL by USING AUTO/MANUAL BUTTON.
When you press the START BUTTON, the machine will feed-in
and cut out a piece of tape for testing purpose
To operate the machine by using MANUAL MODE,press the
STARTBUTTON and feed-in a piece of tape after taking it out.
To operate the machine by using AUTO MODE, the machine will
feed-in a piece of tape automatically.
The signal shows numbers backwards when feeding-in another
piece of tape
When the DISPLAY indicates "0", the buzzer will have a sound.
The DISPLAY indicates the number of pieces that are preset.
Please wait until the buzzer stops.
If you take the tape out before the buzzer stops, the LED LAMP
will flash so you need to press the START SWITCH again.
If you try to change the mode (AUTO/MANUAL) when machine is
operating just press AUTO/MANUAL BUTTON.
- 8 -