VEVOR AT-60 Manual Del Usuario página 7

Load the Tape
Plug in the AC CORD to the AC CORD INLET.
Make sure the POWER SWITCH is off, then plug it into an
appropriately grounded AC outlet.
Turn the POWER SWITCH on.
When the POWER SWITCH is turned on, a buzzer will have a
sound.
At this moment, the mode is set to MANUAL
Press the HOLD DOWN ROLLER RELEASE BUTTON
Place a roll of tape in the machine
Hold the tape by adjusting the TAPE HOLDERS
Adjust the TAPE HOLDERS to a proper width, slide the TAPE
HOLDERADJUST LEVER from the front to the rear of the machine
then close it.
The TAPE HOLDERS should hold the roll lightly in the center of the
cavity of the machine
This is very important because it keeps the tape in the center.
The tape passes over the SENSOR in front of the BLADE UNIT.
To support a larger roll of tape, pull the LOWER HOLDER out
Put the tape on the TAPE FEED ROLLER
Press the FWD BUTTON until the tape comes out from the TAPE
OUTLET!
When using a strong sticky adhesive tape, pull a little bit of tape out
in positioning into the TAPE INLET.
Press the FWD BUTTON continuously for a few seconds, and help
the tape position in the TAPE INLET.
After the tape is loaded and the TAPE HOLDERS are adjusted,
close the HOLD DOWN ROLLER UNIT.
Press the START BUTTON.
Remove the first piece of tape and discard it
When you take the roll of tape out from the machine, pull the tape
backward and press REV BUTTON.
OPERATING INSTRUCTIONS
- 6 -