Nussbaum TTC 600 Manual De Instrucciones página 44

18) Press down on the lever and lower the wheel to bring the edge of the rim about 5 cm from the hooked tool.
Turn the wheel anticlockwise pressing down on lever LA until the tyre comes completely off the rim.
DANGER!
When the beads come off the rim, the wheel will fall.
Check to make sure there are no by-standers in the work area.
MOUNTING
1) If the rim has been removed from the spindle, put it back on the spindle as
described in the section on "CLAMPING THE WHEEL".
2) Lubricate both beads and the rim with tyre manufacturer recommended lubri-
cant.
3) Attach the PC clip to the outside edge of the rim at the highest point (See Fig.
M).
CAUTION!
Make sure the clip is firmly attached to the rim.
4) Take the mobile control unit to work position B.
5) Put the tyre on the platform and lower the spindle (make sure the clip is at the
high point) to hook the first bead on the clip.
6) Lift the rim with the tyre hook to it and turn it anticlockwise about 15-20 cm.
The tyre will be positioned tilted across the rim.
7) Move the tool carrier arm to its non-working position.
Move it to the inside plane of the tyre and rehook it in this position.
8) Check to make sure the hook tool is positioned on the wheel side.
If not, press lever (19, Fig. D) and turn it 180°.
9) Take the mobile control unit to work position D.
10) Move the tool forward until the red reference dot is lined up with the outside
edge of the rim and about 5 mm from it (See Fig. S).
11) Take the mobile control unit to work position C.
12) Move to the outside of the wheel and check the exact position of the hook
visually and adjust it as needed.
Then turn the spindle clockwise until the clip is at the bottom (6 o'clock).
The first bead will be on the rim.
Remove the clip.
13) Take the mobile control unit to work position D.
14) Remove the tool from the tyre.
15) Move the tool carrier arm to its non-working position.
Move it to the outside plane of the tyre.
TTC 600
44
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
M
S