Publicidad
EN
13.4 GUIDE BAR MAINTENANCE
Figure 18.
Make sure that it is turned over periodically to keep
symmetrical wear on the guide bar.
1. Clear the groove of the guide bar with a small
screw-driver, for example.
2. Clean the lubrication holes.
3. Remove burr from the edges and level the cutters
with a flat file.
Replace the guide bar if:
•
the groove is not fit with the height of the drive links
(which must never touch the bottom).
•
the inside of the guide bar is worn and make the
saw chain lean to one side.
14
TRANSPORTATION AND
STORAGE
Before you move the machine, always
•
Remove the battery pack from the machine.
•
Keep hands clear of the trigger switch lockout.
•
Put the guide bar cover on the guide bar and the
saw chain.
Before you put the machine into storage, always
•
Remove all residual oil from the machine.
•
Remove the battery pack from the machine.
•
Clean all unwanted material from the machine.
•
Make sure that the storage area is
•
Not available to children.
•
Away from agents which can cause corrosion,
such as garden chemicals and de-icing salts.
15
TROUBLESHOOTING
Problem
The guide bar
and the chain
become hot and
release smoke.
English (Original Instructions)
NOTE
Possible cause
Solution
The chain is too
Adjust the chain
tight.
tension.
The oil tank is
Add lubricants.
empty.
Contamination
Remove the
causes a block-
guide bar and
age of the dis-
clean the dis-
charge port.
charge port.
Contamination
Clean the oil
causes a block-
tank. Add new
age of the oil
lubricant.
tank.
Problem
Possible cause
Contamination
causes a block-
age of the guide
bar and the oil
tank cap.
Contamination
causes a block-
age of the
sprocket or
guide wheels.
The motor runs
The chain is too
but the chain
tight.
does not rotate.
The guide bar
and the chain
are damaged.
The motor is
damaged.
The motor runs
The chain is
and the chain ro-
blunt.
tates, but the
chain does not
The chain is in
cut.
the incorrect di-
rection.
The chain is tight
or loose.
The machine
does not start.
The machine
and battery are
not connected
correctly.
12
Solution
Clean the guide
bar and the oil
tank cap.
Clean the
sprocket and the
guide wheels.
Adjust the chain
tension.
Replace the
guide bar and
the chain if it is
necessary.
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
sprocket cov-
er.
3. Remove the
bar and saw
chain.
4. Clean the
machine.
5. Install battery
pack and op-
erate the ma-
chine.
If the sprocket
rotates, it means
the motor works
properly. If not,
call your dealer.
Sharpen or re-
place the saw
chain.
Turn the chain
loop to the other
direction.
Adjust the chain
tension.
Make sure that
the battery re-
lease button
clicks when you
install the battery
pack.
Publicidad
