Publicidad
EN
9
INSTALLATION
9.1
UNPACK THE MACHINE
Read the operator's manual carefully to ensure that
you assemble the product correctly. Using a product
that has been incorrectly assembled could lead to an
accident or serious injury.
•
If parts of the machine are damaged, do not use
the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact your
dealer.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
9.2
ADD THE GUIDE BAR AND CHAIN
OIL
Figure 6.
Examine the amount of oil in the machine. If the oil level
is low, add the guide bar and chain oil as follows.
Use guide bar and chain oil that is only for chains and
chain oilers.
The machine comes from the factory without guide bar
and chain oil.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
enters in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. Check the level of oil from time to time.
Do not use dirty, used or contaminated oil. Damage
can occur to the guide bar or saw chain.
English (Original Instructions)
WARNING
WARNING
IMPORTANT
NOTE
IMPORTANT
9.3
FIT THE POWER PRUNER
Figure 2-3.
1. Mount the power pruner head on power pruner
handle to achieve the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
9.4
EXTENSION OF THE POWER
PRUNER
Figure 2-3.
1. Fit the extension pole between the power pruner
handle and the power pruner head to achieve the
maximum length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
Periodically check the tightness of the connection
of the collars.
9.5
USE THE SHOULDER STRAP
Figure 4.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
9.6
CUTTING PREPARATION
Figure 4.
Before you start to cut, make sure that
•
Wear heavy gloves for maximum grip and
protection.
•
Maintain a proper grip on the machine during
operation.
•
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
•
Keep your body to the left of the chain line.
•
Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
•
Never stand directly under the limb you are cutting.
•
Periodically examine the tightness of the collars
during operation.
9.7
INSTALL THE BATTERY PACK
Figure 5.
8
WARNING
Publicidad
