Publicidad
Idiomas disponibles
Idiomas disponibles
2
Route the USB extension cable (long)
inside the dashboard, then connect the USB
cable (short) from the unit.
Position the USB cable so that its connector
(male) comes out from the center console panel.
*
*
* USB connector (male)
Mounting the unit in the dashboard
Using the mounting brackets supplied
with your car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
Example
to dashboard/center console
Bracket
Existing parts supplied
with your car
Note
To prevent malfunction, install only with the mounting
screws .
Attaching the joint cover
1
Attach the joint cover to the mounting
base of the unit, then slide it into the unit
temporarily.
Bracket
Setting up the display
The mounting positions of the display can be
adjusted.
Depth
Height
(within 20 mm
(within 60 mm
(
13
/
in), in 3 steps)
(2
3
/
in), in 7 steps)
16
8
Adjusting the depth of the display
position
1
Loosen the 3 pre-installed screws for depth
adjustment (on top and both sides).
Slightly loosen the screws until you can slide the
connector bracket. Do not remove the screws
from the bracket. Doing so may damage the
parts.
2
Slide the connector bracket to decide the
appropriate depth position.
Adjustable depth: within 20 mm (
3 steps, in 10 mm (
13
Bracket positions 1 to 3 for the display:
1: Slide-out position
2: Intermediate position
3: Slide-in position
Angle
(-10° to +10°, in 3
steps)
Pre-installed screws
13
/
in) (), in
16
/
in) pitch ().
32
3
2
1
17
GB
Publicidad
