5. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
After closing the cover, the control panel
turns white. The appliance is ready to use.
7.3 Cleaning the charcoal filter
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Remove the clips holding the filter bed
(1), then the filter bed (2).
2
8. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
1
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
3. Wash the filter bed in hot water without
using detergent or use a dishwasher.
Set the dishwasher without using rinse
aids or any other detergents. The
dishwasher cannot be filled with dishes.
4. Leave the filter bed to dry or use an oven.
WARNING!
Risk of burns! Refer to safety chapter in
oven user manual.
Set the oven for 10 minutes in the maximum
temperature of 60°C.
5. To install the filter, perform the steps in
reverse order. The filter has to be fully
dried before installing it back into
appliance.
Replace the filter bed every 2 years or when
the cloth is damaged.
7.4 Replacing the lamp
This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
74