Descargar Imprimir esta página

Tintometer Lovibond TC Serie Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Setup location
WARNING
Leaking refrigerant and oil!
Fire. The refrigerant contained within the appliance is envi‐ronmen-
tally friendly, but flammable. The oil contained within the appliance is
flammable. Escaping refrigerant and oil can ignite if they are of high
enough concentration and are exposed to an external heat source.
► Do not damage the pipelines of the coolant circuit and the
compressor.
• Do not setup the appliance in direct sunlight, next to an oven,
radiator or similar.
• The best place to set up the appliance is a dry and well venti-
lated room.
• If the appliance is set up in a very humid environment, conden-
sation can form on the outside of the appliance. Always ensure
sufficient airflow and ventilation in the setup location.
• The more refrigerant there is in the appliance, the larger the
room must be in which the appliance is located. If rooms are
too small, any leak may create a flammable mixture of gas and
air. For every 8 g of refrigerant, the size of the installation space
must be at least 1 m3. Spec‐ifications regarding the refrigerant
contained within the appliance can be found on the type plate
inside the appli‐ance.
• The floor of the setup location must be horizontal and even.
• The setup location must be able to withstand the weight of the
appliance plus the weight when stocked to maximum capacity.
(see Technical data)
Electrical connection
WARNING
Danger of fire due to incorrect positioning!
If the power supply cable or plug touches the back of the appli-
ance, the vibration can damage the power supply cable or the plug
resulting in a short circuit.
► Make sure the power supply cable is not trapped under the ap-
pliance when you position the appliance.
► Install the appliance so that it does not touch any plugs or
power cables.
► Do not connect any appliances to sockets in the area of the back
of the appliance.
► Do not place and operate power strips/power distributors and
other electronic devices (such as halogen transformers) at the
back of the appliances.
Appliance dimensions
Model
A
B
TC710S
1684
597 mm
TC715G
mm
TC720S
1684
747 mm
mm
A = appliance height B = appliance width without handle C = ap-
pliance depth without handle D = appliance depth with door open
E = hinge height
TC 710 S / TC 715 G / TC 720 S_1 02/2024
C
D
E
654 mm 1203
23 mm
mm
769 mm
1468
23 mm
mm
Transporting the appliance
TC 715 G
WARNING
There is a risk of injury from pieces of broken glass.*
When transporting at an altitude of more than 1500 m, the glass
panes of the door may break. This can result in sharpedged frag-
ments, which can cause serious injuries.
► Adopt suitable protective measures.
► On initial setup: Transport the appliance in its packaging.
► When transporting after initial setup (e.g. relocation): Transport
the appliance unloaded.
► Transport the appliance upright.
► Use two people when transporting the appliance.
Unpacking the appliance
► Check the appliance and the packaging for transport damage.
Contact the supplier immediately if you suspect any damage. Do
not connect the appliance to the power supply.
► Remove all materials from the back or the side walls of the ap-
pliance that may prevent proper installation or prevent air flow
and ventilation.
► Take the power cable off of the rear of the appliance. Remove
the cable retainer when you do so, otherwise there will be
vibration noise.
Removing the transport lock
► Pull tab (1) forwards.
► Take off transport lock (2) in upwards direction.
► Base holder remains on the appliance.
Setting up the appliance
CAUTION
Risk of injury and damage.
► Use 2 people to set up the appliance.
CAUTION
Risk of injury and damage.
The door can strike against the wall and become damaged as a result.
In the case of glass doors, the damaged glass can cause injuries.
► Protect the door from striking against the wall. Attach a door
stopper, e.g. felt stopper, to the wall.
► Connect all necessary components (e.g. power cable) to the back
of the appliance and route to the side.
Note
Cables can be damaged.
► Do not crush the cable when pushing the appliance back.
► Install the appliance either as free-standing or directly against a wall.
GB
13

Publicidad

loading

Este manual también es adecuado para:

Lovibond tc 710 sLovibond tc 715 gLovibond tc 720 s