Tintometer Lovibond TC Serie Manual De Instrucciones página 16

Glass door*
► Screw the handle onto the opposite side.
► Put the closing bracket on the opposite side.
NOTICE
The holes are pre-marked and must be pierced with the selftap-
ping screws.
► Move the hinge to the opposite side.
WARNING
Risk of injury and material damage if the door tips out!
► Tighten the bearing pins to the specified torque.
► Put the pin back into the hinge (1).
► Tighten the pin (2) to a torque of 12 Nm.
► Unscrew the hinge again.
NOTICE
Risk of injury due to tensioned spring!
► Do not disassemble the door closing system (1).
16
► Turn the closing system (2) until it clicks.
► The tension of the closing system is released.
► Unscrew the hinge (3).
► Put the door closing system in the hinge.
► Make sure the pin chamfer (1) faces the round hole when you
put it in.
► Put the cover plate on the opposite side.
► Screw the hinge onto the opposite side.
NOTICE
Correct alignment and tension are important for the closing system
to work properly.
Left-hinged (A) / Right-hinged (B)
► Turn the closing system against the resistance until the bar of
the closing system (1) points outwards.
TC 710 S / TC 715 G / TC 720 S_1 02/2024