Tintometer Lovibond TC Serie Manual De Instrucciones página 17

► The closing system automatically stays in this position.
► The closing system is now aligned and pretensioned.
► Put the hinge into the door.
NOTICE
Risk of injury if the door tips out!
► Hold the door.
► Together with a second person, lift the door from the ground.
► Carefully put the door on the closing system with the door
opened at a 90° angle.
► Screw on the hinge.
► Put on the cover.
► Screw on the door latch.
TC 710 S / TC 715 G / TC 720 S_1 02/2024
► Open the door.
► Hook in the front covers (1) on the side and snap them into
place on the inside.
► Snap on the top cover (2) from above.
► Close the door.
► The door has now been reversed.
Aligning the door
If the door is not straight, you can adjust it on the lower hinge.
► Remove the middle screw on the lower hinge.
► Slightly undo both screws and move the door with the hinge
to the left or right.
► Fully tighten the screws (the middle screw is no longer needed).
► The door is now straight.
Connecting the appliance
WARNING
Incorrect connection!
Risk of fire.
► Do not use an extension cord.
► Do not use a multipoint connector strip.
NOTICE
Incorrect connection!Damage to the electronics.
GB
17