Publicidad
Idiomas disponibles
Idiomas disponibles
•
If the gate doesn't slide freely moved by hand, adjust the height of the gear
rack accordingly until the full length of gate slides freely when operated
manually.
LIMIT SWITCH STOPS
a) Gear rack
b) Limit switch stop
c)
Limit switch stop bracket
Included in the device kit are two magnet limit switch stops with two different
polarities: stop in black color (N), stop in blue color (S). These two stops must be
fitted to the gear racks on your gate to ensure safe operation. Before you fit the
limit switch stops, you should install them on the their brackets first. After fitting,
set on the control board to enable the gate into manual control mode (refer to the
EN
Publicidad
