Publicidad
Idiomas disponibles
Idiomas disponibles
indicator lights L1-L5 will be on in sequence, then all will flicker once and go
off.
NOTE: After changing the opening direction, L1 and L2 will flicker together, it's a
notice that reminding you to re-set the running travel for the gate. Before re-
setting, it's very important to enter into manual control mode to confirm the
polarities of the limit switch stops are correct and well contacted to the magnetic
limit switch.
ALARM LAMP SETTING (L5)
This setting is to select the working mode of alarm lamp (blinking or steady on).
Operation instruction:
• Press and hold "PROG" button for 3 sec. to enter into basic menu. The
indicator light L0 will flicker once, then L1 will be steady on.
• Press "PROG" button again for 3 sec. to enter into advanced menu. L0 will
flicker twice, then L1 will be steady on.
• Press "+" button four times to select alarm lamp working mode option. The
indicator light L5 will be steady on.
• Press "SET" button once to enter into alarm lamp working mode setting. The
indicator light L1 will show the current setting.
• Press "+" or "-" button to set the alarm lamp working mode. The indicator light
L1 on or off will indicate the alarm lamp working mode. (L1 off: blinker; L1 on:
steady on)
• Press "SET" button once to save and system will automatically exit. The
indicator lights L1-L5 will be on in sequence, then all will flicker once and go
off.
OTHER MENU SETTING
EN
Publicidad
