Publicidad
4
FULLY TIGHTEN THE DRAW BOLTS.
5
INSTALL THE M6 X 45 MM SCREWS.
6
CONTINUE WITH THE REST OF THE ASSEMBLY AND INSTALLATION.
Instruction #1036297A-4/7
X Nm
3 Nm
2.5 Nm
Refer to your HomeBase instruction and follow the rest of the
installation steps starting with the strap installationa step.
Now that the draw bolts are aligned, fasten
them securely with a torque of 3 Nm. While
tightening, pull down on the bolts to ensure
they are properly engaged. Repeat steps 3
and 4 for the other side of the HomeBase.
Install an M6 x 45 mm screw with a
washer and fasten each riser foot
firmly with a torque of 2.5 Nm. Repeat
for the other side of the HomeBase.
2X
2X
4X
4X
Publicidad
