CST/BERGER 56-DGT2 Manual De Instrucciones página 6

Thank you for purchasing the Electronic Digital Transit/Theodolite. Please read this
manual thoroughly before operation
MODELS
56-DGT2 2 Sec. Electronic Digital Transit/Theodolite
EN
56-DGT10 5 Sec. Electronic Digital Transit/Theodolite
Copyright© 2005-2006 CST/Berger. All rights reserved
The information contained herein is proprietary information of CST/Berger, and is subject to
change without notice.
This document shall not be copied or otherwise reproduced without CST/Berger's written consent.
FEATURES FIG.1
1 Targeting Sight
2 Objective Lens
3 Horizontal Clamp Knob
4 Horizontal Tangent Screw
5 Display Window
6 Operation Keys
7 Leveling Screws
8 Instrument Center Mark
9 Optical Plummet
10 Tripod Base Plate
CALIBRATION
This quality CST/Berger instrument has been inspected twice for accuracy before leaving the
factory. The instrument has also been given the best protection possible against damage during
transportation. Even with these precautions, the instrument is subject to rough handling during
shipment. To protect yourself against the possibility of using an instrument which is out of
adjustment, we suggest that you have the instrument checked by a competent person before
using it.
Note: Please read the manual thoroughly before starting the following test.
The following test can be performed to check the instrument's accuracy:
Set up the instrument in an area that is as level as possible and which is about 220 feet long. Place
two matching level rods (or drive two pieces of strapping into the ground)about 200 feet apart with
6 • DGT2 - DGT10
11 Carrying Handle
12 Handle Screw
13 Plate Level
14 Tribrach Clamp Knob (DGT10 Only)
15 Battery Case
16 Focusing Knob
17 Eyepiece
18 Vertical Clamp Knob
19 Vertical Tangent Screw
20 Circular Level (DGT10 Only)