Assembling The Blower - Stihl BGE 61 Manual De Instrucciones

English
NOTICE
Vacuuming abrasive material (such as
grit, stone chips, etc.) causes the blower
wheel and blower housing to wear at a
rapid rate. This results in a considerable
loss of suction power. In such a case
you should contact your dealer. STIHL
recommends a STIHL servicing dealer.
Take particular care when vacuuming
wet leaves since they may block the
blower wheel and elbow.
Watch out for small animals when
vacuuming in open areas, yards and
gardens.
10

Assembling the Blower

Disconnect the plug from the power
N
supply.
Mounting the Blower Tube
BGE 71, BGE 81:
Your blower can be switched on only
when the blower tube is properly
mounted. The union nut activates a
switch which closes the circuit to allow
the motor to be switched on.
4
5
3
Line up the recesses. The arrow (2)
N
must be on the top of the blower
tube (1).
Push the blower tube (1) into the
N
blower housing stub (3) as far as the
stop.
Push the union nut (4) over the
N
blower housing stub (3) and turn it in
the direction of the arrow until the
tab (5) engages the opening (6) in
the union nut.
BGE 71, BGE 81:
You will hear the safety switch being
N
activated.
Mounting the Nozzle
Push the nozzle (5) onto the blower
N
tube (1) as far as lug (6),
position (a) (long) or position (b)
(short), and rotate the nozzle in the
direction of the arrow to it lock in
2
position.
1
Removing the Blower Tube
6
Switch off the motor.
N
Press down the lock button by
N
inserting a suitable tool through the
opening in the union nut.
Rotate the union nut (4) in the
N
direction of arrow as far as the stop.
Remove the blower tube (1).
N
a b
6
1
4
BGE 61, BGE 71