Phase Rotation Indicator/English
Do not use Phase Rotation Indicator around explosive gas, vapor, or
dust.
Do not use Phase Rotation Indicator in a wet environment.
Symbols
The following symbols appear on Phase Rotation Indicator or in this
manual.
Table 1. Symbols
Risk of electric shock
Risk of Danger . Important
information See manual
Hazardous Voltage.
Equipment protected by
double or reinforced
CAT
Insulation
Elements of Phase Rotation Indicator
Indicators, buttons, and jacks are shown in Figure
1.
1
1
2
PHASE ROTATION INDICATOR
2
3
3
4
4
5
5
Figure 1. Phase Rotation Indicator
2
Earth
AC or DC
Conforms to EU directives.
OVERVOLTAGE(Installation)CATEGORY
III,Pollution Degree 2 per IEC 1010-1
refers to the level of Impulse provided.
Equipment of OVERVOLTAGE
CATEGORY III is equipment in fixed
installations (e.g.,electricity meter and
primary over-current protection
equipment.)
Test lead input jack
L1,L2,L3 Indicators
Clockwise Rotation LCD Indicator
Counter-Clockwise Rotation LCD Indicator
Brief Instructions on instrument rear
Determine the Rotary Field Direction
To determine the rotary field direction:
1. Connect the test probes to the end of the test leads.
2. Connect the test probes to the three mains phases.
3. The green ON indicator shows that the instrument is ready for
testing.
4. Either the clockwise or counter-clockwise rotary indicator illuminates
showing the type of rotary field direction present.
5. The rotary indicator lights even if the neutral conductor, N, is
connected instead of the Test lead input jacks.
Unpacking Phase Rotation Indicator
Phase Rotation Indicator ships with the following items:
3 pieces self-retaining test probes
Alligator clip
Users Manual
If an item is damaged or missing, contact the place of purchase
immediately.
Specifications
Environmental
Operating Temperature: 0℃ to +40℃
Pollution Degree: 2
Type of protection: IP40
Mechanical Specifications
Size:(H x W x D): 130mm x 69mm x 32mm.
Weight: 130g
Safety Specifications
Phase Rotation Indicator/English
3