Parkside PLS 3000 A1 Traduccion Del Manual De Instrucciones Originale página 39

Trouble shooting
A
Problem Possible cause
No mains power supply
Worn out carbon brushes
Appliance Motor faulty
won't start
On/Off switch (4) defective
The suction tubes (16) and collection
bag (14), and/or blower tubes (9)
and protective cover
(7) are not correctly mounted.
Internal loose contact
Intermittent
Power cable damaged
operation
On/Off switch (4) defective
Collection bag (14) is full
Weak or
no suction
Collection bag (14) is dirty
power/
Impeller, blower or suction pipe
throughput
(9/16) is clogged or blocked
Impeller does
Foreign body blocking the impel-
ler
not move
Corrective action
Check the socket, cable, line, plug and
fuse and have them repaired by a qua-
lified electrician if necessary.
Send in to Service Centre for repair
See the section on „Initial start-up"
Send in to Service Centre for repair
Empty collection bag
Clean collection bag
see „Removal of clogging
and blockage"
Remove the blockage (see „Removal
of clogging and blockage")
GB MT
39